_________________________ | | This package should contain: | X.Jump | | | X.JUMP.DOX | Created by Mr. Mayhem | X.JUMP | Alcatraz (714) 991-5756 | X.JUMP2 | 2400/9600 Baud | | PCPable through CASAN | |_________________________| About X.Jump ------------ These are two "use" files for ACOS which act similar to ON X GOTO. The following set up MUST be followed when using X.JUMP use "a:x.jump",x <- set x to any variable, with a number from 1-64 goto qscan <- jump to this label if x=1 goto subs <- jump to this label is x=2 . . etc The set up for X.JUMP2 is the same, except the number may be from 0-63. Ending Comments: ---------------- Make sure you have the correct amount of labels after the use, so that you don't get a syntax error. X.Jump is faster than the normal " if x=43 goto label". However you may not notice the difference if your running over 1 mhz, or if your jumping to low numbers. But overall it is faster. If you have any questions or comments give my board a call.